- Catalog Index
- Part# Search
- Fastener Guide
- Screws
- Screw & Bit Finder
- Terms
- Returns
- Anchors
- Awesome Deals
- Bit Extenders
- Combo Drive Bits
- Cup Washers
- Double Ended Drive Bits Drive
- Hanger Bolt Driver
- Hex Drive Bits
- Hex Tamper Proof Drive Bits
- Magnetic Bit Holders 1PC
- Magnetic Bit Holders 2PC
- Magnetic Nut Setters .250
- Magnetic Nut Setters .3125
- Magnetic Nut Setters .375
- Magnetic Nut Setters .4375
- Magnetic Nut Setters .500
- Misc Bit Products
- Nut Setter For Stainless
- Phillips ACR Drive Bits
- Phillips Drive Bits
- Phillips Magnetized Drive Bits
- Phillips Misc Drive Bits
- Phillips Reduced Drive Bits
- Power Chuck Bit Holder
- Pozi Drive Bits
- Quick Release Bit Holders
- Screws
- Sink Clips
- Slotted Drive Bits
- Solar Install Hardware
- Spanner Drive Bits
- Square Drive 2 Piece Bits
- Square Drive Bits
- Square Drive Magnetized Bits
- Super Magnetic Bit Holders
- T10 Torx Drive Bits
- T15 Torx Drive Bits
- T20 Torx Drive Bits
- T25 Torx Drive Bits
- T27 Torx Drive Bits
- T30 Torx Drive Bits
- T40 Torx Drive Bits
- T6 Torx Drive Bits
- T7 Torx Drive Bits
- T8 Torx Drive Bits
- T9 Torx Drive Bits
- Torx Tamper Proof Drive Bits
Index
Part# Search
Fastener Guide
Specials
Screws
Screw & Bit Finder
Anchors
Drivebits
Terms
Returns
Terms
Returns
Catalog Contents: Combo Drive Drawer Front Adjusting Screw
Catalog Contents > Anchors > Insert and Power Bits > Phillips Drive Pan Head Hardware Screws > Cabinet Installation Screws > Specialty Connecting Screws (Euro-Style) > Combo Phillips-Slotted Round Washer Head > Phillips Drive Bright Brass Hinge Screws > Phillips Drive Flat Head Hardware Screws > Phillips Drive Flat Head Assembly Screws > Combo Drive Drawer Front Adjusting Screw
0 Results
(Showing 1–0)
Page 1
of 0
Drawer Front Adjusting Screw
1/2" Outside Diameter, Large Round Washer Head provides for better adjustment control.
When building a typical 5 piece drawer box, it is desirable to have the ability to move and precisely adjust the drawer front in order to align all of the drawer faces.
- An oversize hole (5/16" - 3/8") is drilled through the drawer box
- The drawer front is then attached using two Drawer Front Adjusting Screws.
- During installation, the Drawer Front Adjusting Screws can be loosened slightly to allow for drawer front adjustment and alignment. The screws are then re-tightened
- A hardware screw or "set-screw" can be used to secure the drawer front into place.
*All lengths and gauges may not be available with
each head style, thread style, special feature or finish.
Please see individual parts in catalog for specifics.